WC 890 is a waterborne resin system which provided excellent protection and durability. It is a low VOC coating that has been formulated for direct to metal application for high quality, high gloss, quick dry finish. It is available in a wide variety of colors. This system is also available as a primer with several color choices.

Waterborne coatings are used where safety and VOC compliance are a consideration. Reducible with water, fast dry, dry to touch in 30-45 minutes at 75° F. Recoatable within 24 hours with minimal surface preparation. Excellent exterior durability.

Typical Physical Properties

VOC lb/gal: Less than 3.5
Flash Point: 130 T.C.C.
% Solids by weight: 24.6 to 33.2
% Solids by volume: 21.2 to 27.1
Coverage 1 mil(s) dry: 347 to 426 sq. ft (100.0% efficiency)
Dry to touch: 30 - 45 minutes
To handle: 2 to 4 hours @ 75°
Hard: 24 hours @ 75°
Gloss @ 60° : 80-90
Recommended wet film: 3.7 to 5.9 mils
Recommended dry film: 1.0 to 1.3 mils

Application Instructions

Surface Preparation:

New Steel - Surface must be dry and free of contamination. Remove all weld spatter and grind all rough welds and edges to smooth contour.

Previously Painted Surfaces - Must be free of oil, grease, or other contamination. For best results, spot blast exposed areas to be primed. Power tool brushing may be used for minor touch up.

Spray:

Thoroughly mix coating prior to applying to substrate. Surface shall be dry, above 60° F and 5° above the dew point, and free of rust bloom. Double lap all welds, seams, corners, and edges to insure proper thickness. Make even parallel passes with 50% overlap to provide uniformity.
This product has been formulated to be used at full strength. If reduction is required, water should be used.

Other Properties

Salt Fog: *ASTM B-117 **500 hours
Humidity: *ASTM D-2247 **1000 hours
Impact: Good
Flexibility: Good
Hardness: HB to H
ph: 8.0 to 8.8
Weather-Ometer: *ASTM D-4587 300 hours
Freeze-Thaw: Passes 5 cycles

*ASTM = American Society for Testing Materials
**BONDERITE 1000 PANELS

The above technical data is accurate to the best of our knowledge. No warranty is expressed or implied as application methods and conditions and intended use is beyond our control.